• (1) Pair Rockville RWB90B Black 8" 300w Marine Wakeboard 360° Swivel Tower Speakers
• (1) MB Quart NA2-400.2 400w 2-Channel Amplifier Amp For Polaris/ATV/UTV/RZR/CART
• (1) MB Quart N2-WBT Wired Bluetooth Preamp Controller, Boat Polaris/ATV/UTV/RZR/CART
• (1) Rockville RWK8ATV OFC Copper 8 AWG Gauge Amp Installation Wire Kit 4 RZR/ATV/UTV

Videos of RWB:

Includes:

• (2) Wakeboard Speakers
• (2) 360° Swivel Mounting Brackets
• Integrated Grill
• Installation Hardware

Description:

• No exaggerated power ratings: These speakers are rated with true world RMS ratings. No bootleg or exaggerated power ratings like other brands. These speakers are 200 watts RMS and 300 watts peak. (200 watts RMS is equal to about 500 watts rated by other brands)
• Marine grade components and materials: these speakers are truly marine grade. They will not get damaged by water, salt water, or moisture. In addition the terminals (which are normally the first part of a marine speakers that gets damaged by water are made out of stainless steel and they are completely rustproof. There is also an additional waterproof coating cut completely protect the speakers.
• These can withstand all elements on the water for a lifetime of worry free use
• The mounting screws are longer than other versions we carry to accommodate thicker mounting bars. In addition to wakeboard tower's on boats, we tested these to be perfect for installing in Jeep Cherokee vehicles and even ATV's.
• We’ve added a new and improved nylon mounting bracket. Nylon is strong, light weight, and can withstand the toughest conditions. The bracket features a special UV coating to protect it from the elements. A 360° rotating mechanism built into the bracket allows you to position the speaker in any direction for optimum listening enjoyment. This also gives you the ability to rotate the speaker to the front or rear of your boat for different applications.

Features:

• Pair Rockville RWB90B Black 8" 300w Marine Wakeboard 360° Swivel Tower Speakers
• 8" Two-Way High Fidelity Speaker System
• Adjustable Nylon Mounting Bracket Reinforced With Embedded Steel
• Includes Stainless Steel Mounting Hardware
• 1" Polymide Dome Neodymium Midrange Tweeter
• Built-In Two-Way Crossover Network
• Fully Marinized Against Salt & Fresh Water Conditions
• Completely Water / Rust Resistant
• Terminals Are Sealed with Rubber Gaskets
• Specially Tuned for PA Voice Over
• Polypropylene Mica Injected Cone with Santoprene Surround
• High BL Magnet Motor Structure
• Y30 High Density Magnets
• Oversized 1.25” Kapton Voice Coil
• Large mounting screw accommodates roll bars found on many off road vehicles such as Jeep Wranglers, and ATV's equiped with a roll bar/cage.
• These Wakeboards Fit bars ranging from 1.26" 2.87"
• Color: Black
• Includes 65mm and 80mm screws that accommodate Jeep Wrangler and any roll bar
• Includes Stainless mounting hardware that wont rust or corrode

Details:

• Peak Power Handling: 300 Watts
• RMS Power Handling: 200 Watts
• Frequency Response: 60–20,000 Hz
• Sound Pressure Level: 98dB @ 1w/1m
• Impedance: 4 Ohms
• Mounting Depth: 10.5"

Owner's Manual

Features of NA2-400.2:

• MB QUART NA2 400.2 400w 2-Channel Amplifier Amp For Polaris/ATV/UTV/RZR/CART
• Marine Grade Protection: Yes - Amplifiers are ABYC & ASTM certified which defines that marine amplifiers must use conformal coated PC boards to resist corrosion from salt spray & moisture.
  
• Pre-Amp Circuitry: Q-Stasis Pre Amplifier Stage - The highly engineered Q-Stasis pre-amplifier stage reduces incoming noise from source units dramatically improving sound quality
  
• Inputs: 1 Pair, RCA Nickel-Plated - High temperature impact resistant with hex screw terminals that allow for secure connections and is erosion resistant
  
• Operation Mode: Two channel operation - Flexible installation allows this amplifier to run in two channel or bridged mono mode.
  
• Crossover / Signal Shaping: Switched FULL / LPF / HPF - Complete control of amplifier signal, essential when using two or more amplifiers
  
• Class / Topology: Full Range Class D - Highly efficient circuit topology which helps the amplifer develop a lot of power in a very small heatsink.
  
• Output Devices Technology: PWM MOSFET Power Supply - Stable power through the PC board with minimal heat generation
  
• Heat Sink: Aluminum - Quickly dissapates heat to allow the amplifer to run lower impedance for longer duration
  
• Power Supply: Simpatico Coil Design - The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices
  
• Output Connections: Quick Dissconect Wires, RCA Connections - Quickly remove amplifer when you are putting machine up for the winter of as a security precaution
  
• Connections Type: Gold-plated connections - Gold-plated power, ground, speaker and RCA corrosion resistant connections
  
• Diagnostics: Three-stage protection circuits - Monitor thermal, overload, DC, and speaker short protection with lighted indicators on the amplifier end panel
  
• Marinized / Waterproof: Yes - Water resistant for durability in any environment

Specifications:

• Class: Full Range Class D
  
• Variable Voltage: 0.2V~9V
  
• Signal to Noise Ratio: >90dB
  
• Frequency Response: 20Hz-20kHz
  
• Crossover Type: Electronic 12dB Per Octave
  
• Low Pass Crossover: Switch Low Pass 300 Hz
  
• Bass Boost: 0-12dB@45Hz
  
• Subsonic Filter: 60Hz
  
• Power @ 2-Ohms: 2 x 200W
  
• Power @ 4-Ohms: 2 x 100W
  
• Total Channels: 2
  
• Audio Inputs: RCA
  
• Power Terminal 12v/GND: Molex 10 ga
  
• Speaker Terminal Wire Gauge: Molex Plug Connector
  
• Fusing: 1 x 30 Amps
  
• Certifications: Marine & Powersports
  
• Dimensions: 3.70 X 5.51 X 1.77 in (9.4 X 14.0 X 4.5 cm)
  
• Weight: 2.12 lbs (0.96 kg)

Description of N2-WBT:

The MB Quart Nautic bluetooth controller is simple source unit solution designed to mount in a standard switch or accesory location. Features include: Back lighting and RCA outputs (Left & Right).

Features:

•  MB QUART N2-WBT Wired Bluetooth Preamp Controller, Boat Polaris/ATV/UTV/RZR/CART
• Marine Grade Protection: Yes - Meets or excceds the American Boat and Yacht Council (ABYC) marine electronics standards and the American Society for Testing and Materials (ASTM)
  
• Source Type: Bluetooth - Allows to music via Bluetooth enabled devices
  
• Input Types: Bluetooth and 3.5mm jack - Bluetooth enabled devices and 3.5mm input from headphone output of mobile music device or phone
  
• Control Buttons: Fingertip Joystick - Play/Pause, Tracks Forward/Back, Volume Up/Down and Power On/Off are all protected from the elements with the the unique Fingertip Joystick
  
• Bluetooth Connect: Yes - Bluetooth Connect allows your phone or other Bluetooth enabled device to be quickly paired to the controller without a complicated pairing process.
  
• Additional Inputs: 1 pair RCA (Left & Right)
• Bluetooth Range: 32' - 10 Meter
  
• Frequency Response (Aux In): 20Hz - 20kHZ
  
• Pre-amp Outputs: 1pr Left/Right
  
• Pre-amp Voltage: 2V
  
• Display Type: Backlight
  
• Display Backlit: Dial is backlit
  
• Dimensions Mounting Hole: Swich Hole 0.83" x 1.41" (2.1cm x 3.58cm)
  
• Dimensions Mounting Depth: 2.5" (6.35cm)
  
• Dimensions Mounting Bezel: 4.15" (10.5 cm)
  
• Product Weight: 1.0 lbs (0.45 kg)
  
• Product Dimensions: 3.5" (8.89cm)

Video of RWK8ATV:

Features:

• Rockville RWK8ATV 8 AWG Gauge Amplifier/Amp Installation Wire Kit For Motorcycle/RZR/ATV/UTV
• 6 Foot 8 Gauge 100% OFC, Red Flexible Power Cable with 3’ Black Poly Woven Mesh to better resist chemicals in the battery compartment
• 6 Foot 8 Gauge 100% OFC, Black Flexible Ground Cable
• (2) 4 Foot 16 Gauge 100% OFC black Flexible Speaker Cables Protected by black nylon mesh
• 6 Foot Pre-terminated ring terminals make connections to the battery simple
• (1) Silver AGU Fuse Holder – Clear Shell and Clear Blue Bottom Bracket with Blue Waterproof Ring
• (1) 60A AGU Fuse
• (2) Ring Terminals
• (2) Spade Terminals
• (4) Speaker Cable Terminals
• (4) Washers
• (10) White Cable Ties
• (1) hexagon spanner