Authorized Hifonics Dealer!

Description:

The BXX1200.1D is a 1200 watt mono amplifier featuring Super Class D™ technology with an NGSD digital chip to provide you with an extremely efficient, low temperature, high amplification system that others only dream about. The rock solid Ultra-Fi™ MOSFET outputs are selected for both balance and output power. This keeps power smooth even during demanding peak in the music. All Mono and five channel amplifiers include a bass remote to put the bass control at arm’s length. The amplifiers protection condition is also shown by blue illumination for normal operation and red for a short being present and requires the attention of an installer.

Low Noise Pre-Amplifier Circuitry
Maximum low voltage signal from the source unit comes into the amplifier circuit with minimal distortion

RCA Inputs
Nickel-plated RCA jacks create the most efficient audio connection and resist corrosion

Operation Mode
Mono only

Crossover Type
Variable electronic crossovers allow for complete control of the sound

Electronic Equalizer
Control of amplifier output with on-board electronic crossover to tailor specific frequencies to speakers and subwoofers.

Class / Topology
Super D-Class designs which employ high-speed microprocessors with proprietary d/a conversion algorithms to efficiently control the current consumption. At very high listening levels, Hifonics amplifiers with Super D-Class circuitry result in lower distortion, higher current efficiencies and less heat than conventional D-Class amplifier designs

Output Device Technology
The Ultra-Fi MOSFET is designed for music production vs just electronics output power. It produces very musical high power with high efficiency for cooling and minimal distortion
Heat sink. Classic aluminum Hifonics design to minimize heat build up on the Ultra-Fi output devices

Power Supply
Simpatico coil design. The dual coil pulse width modulated power supply keeps voltage constant through the Ultra-Fi output devices

Output Connections
High temperature impact resistant nickel plated connectors with allen head set screws which allow for secure termination of wire and creates an erosion resistant seal

Connection Type
Molded and angled. Secure connection for all power, ground and speaker connections. Angled for ease of access while creating a clean wire management profile

LED System Protection Circuitry Diagnostics
Monitor overload and speaker short protection with illuminated indicators on the amplifier end panel

Bass Remote Included
Wired bass remote allows adjustments to bass frequencies from the control which can be mounted anywhere in the vehicle.

Phase Adjustment
Phase 0-180°

Features:

• Hifonics Brutus BXX1200.1D 1200 Watt RMS Class D Mono Amplifier
• Power @ 1 Ohm: 1 x 1200 Watts
• Power @ 2 Ohms: 1 x 600 Watts
• Power @ 4 Ohms: 1 x 400 Watts
• Class: Super D Class™
• Variable Voltage: 9V - 0.2V
• Signal to Noise: >95dB
• Frequency Response: 10Hz - 50kHz
• Crossover: Electronic
• Variable Low Pass Crossover 12dB Per Octave: 30Hz - 250Hz
• Bass Boost: 0 - 10dB
• Subsonic Filter: 15Hz - 35Hz
• Phase Shift: 0° - 180°
• Total Channels: 1
• Audio Inputs: RCA
• Audio Outputs: RCA
• Power Terminal 12V/GND: 4 AWG
• Speaker Terminal Wire Gauge: 12 AWG
• Fusing: 80Ax1
• Total Harmonic Distortion (THD): <0.10%

Click here for the Owner's Manual