Package Includes:

• (1) Rockville dB11 1400 Watt Peak/350 Watt Dyno-Certified RMS Mono 2-Ohm Amplifier Car Amp+Bass Remote
• (1) Engauge by Memphis KIT8 8 Gauge Amplifier Amp Installation Wire Kit 17 ft. RCAs

---

Video of dB11:

What's In The Box:

• (1) dB11 Amplifier
• (1) Bass Remote
• (1) Birth Sheet with Tested Power
• Owner's Manual
• Mounting Hardware
• Warranty

Features:

• Rockville dB11 1400 Watt Peak/350 Watt Dyno-Certified RMS Mono 2-Ohm Amplifier Car Amp+Bass Remote
• Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc)
  - 2 Ohm: 350 Watts x 1 Channel <1% THD+N
  - 4 Ohm: 220 Watts x 1 Channel <1% THD+N
• Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc)
  - 2 Ohm: 1400 Watts x 1 Channel
  - 4 Ohm: 880 Watts x 1 Channel
• High-Speed MOSFET Power Supply
• Optical Coupler Class “D” Technology
• Fully Adjustable 12dB / Octave Crossover with Differential Circuitry
• Low Pass Filter: 50Hz - 250Hz
• Subsonic Filter: 15Hz - 55Hz
• Phase Control
• Full IC-Controlled Protection Circuitry
• Fully Adjustable 12dB Bass Equalizer
• Mute and Delay Soft Start System
• Status Mode LED Indicator
• Minimum THD at Rated Power: <0.1%
• S / N Ratio: >90dB
• Under Voltage Protection at 10V
• Over Voltage Protection at 16V
• Frequency Response: 15Hz - 250 Hz

Owner’s Manual

---

Features of MEMPHIS KIT8:

• (1) 17ft 8GA blue power wire, 7×42/0.15mm, OD:5.8mm, CCA
  
• (1) 3ft 8GA black ground wire, 7×42/0.15mm, OD:5.8mm, CCA
  
• (1) 17ft 2ch side by side interconnect
  
• (1) 17ft blue remote turn on wire, 32/0.15mm, OD:2.1mm, CCA
  
• (1) AFS fuse holder, zinc parts, nickle plated
  
• (1) AFS fuse, 40A, nickel
  
• (1) 8GA 5/16" nickel ring terminal
  
• (1) Blue boots
  
• (1) 8GA 1/4" nickel ring terminal
  
• (1) Black boot
  
• (2) 8GA #10 nickel spade terminal
  
• (2) 8GA boots, one blue, one black
  
• (1) 12-10 nickel speaker terminal
  
• (1) Red boots for speaker terminal
  
• (1) 8GA grommets
  
• (10) 4" black wire ties
  
• (1) Self-tapping screws
  
• (1) Wafer head #8×3/4" self tapping screw
  
• (1) 16-18GA butt connector
  
• (1) Poly bag for accessories
  
• (1) Poly bag with header card